Metabo HPT C 3607DWA Instructions De Sécurité Et Mode D'emploi page 19

(1) Set the cutting volume at maximum, and place the
Circular Saw as shown in Fig. 15.
Wrench
Lock lever
Fig. 15
(2) Depress the lock lever, lock the spindle, and remove
the hexagonal fl ange bolt and washer (B) with the
wrench.
(3) While holding the lower guard lever to keep the lower
guard fully retracted into the saw cover, remove the
saw blade (Fig. 16).
Saw blade
Fig. 16
4. Check performance of lower guard
WARNING
Make absolutely sure that the lower guard is not
fi xed. Also, check and see if it can move smoothly.
If the saw blade is kept exposed, injury can result.
00Book̲C3607DWA̲NA.indb 19 00Book̲C3607DWA̲NA.indb 19
Loosen
Lower guard lever
Saw cover
The lower guard (refer to Fig. 17) serves to protect
your body from coming into contact with the saw
blade. Make absolutely certain that the cover
smoothly performs to cover the saw blade. If the
lower guard should not move smoothly, never use it
without repairing it.
In such a case, get in touch with the store where
you bought the circular saw or the metabo HPT
AUTHORIZED SERVICE CENTER for necessary
repair.
Fig. 17
5. Check for proper operation of the brake
This circular saw features an electric brake that
functions when the switch is released. Before using
the circular saw, ensure that the electric brake
functions properly. If it does not, bring the tool to a
metabo HPT AUTHORIZED SERVICE CENTER.
6. Prepare a wooden work bench (Fig. 18)
Since the saw blade will extend beyond the lower
surface of the lumber, place the lumber on a work
bench when cutting. If a square block is utilized
as a work bench, select level ground to ensure it is
properly stabilized. An unstable work bench will result
in hazardous operation.
Lumber
Work bench
Fig. 18
CAUTION
To avoid possible accident, always ensure that
the portion of lumber remaining after cutting is
securely anchored or held in position.
7. Check if the cutting depth lever and incline lever are
tightened.
If the the cutting depth lever to adjust cutting depth
(Fig. 21) and the incline lever to adjust angle of
inclination (Fig. 22) are loose, injury can result. Make
sure that they are tightened securely.
English
Lower guard
Base
Saw blade
19
2021/06/10 16:51:43 2021/06/10 16:51:43