Metabo HPT C 3607DWA Instructions De Sécurité Et Mode D'emploi page 23

State of lamp
Lights ;
The battery remaining power is
over 75%
Lights ;
The battery remaining power is
50%–75%.
Lights ;
The battery remaining power is
25%–50%.
Lights ;
The battery remaining power is
less than 25%
Blinks ;
The battery remaining power
is nearly empty. Recharge the
battery soonest possible.
Blinks ;
Output suspended due to high
temperature. Remove the
battery from the tool and allow it
to fully cool down.
Blinks ;
Output suspended due to failure
or malfunction. The problem
may be the battery so please
contact your dealer.
As the remaining battery indicator shows somewhat
diff erently depending on ambient temperature and
battery characteristics, read it as a reference.
NOTE
Do not give a strong shock to the switch panel or
break it. It may lead to a trouble.
5. Cutting procedures
CAUTION
● Recheck that the saw blade is securely clamped.
● Confi rm that the incline lever and the cutting
depth lever are adjusted correctly.
(1) The front of the base has a 90° guide notch and a 45°
guide notch for vertical and bevel cutting. The guide
notches enable you to guide the saw along the cutting
lines marked on the workpiece.
Also, the saw has the inner guide notches located on
the insides of the base as shown in Fig. 27 to keep the
straight cutting.
00Book̲C3607DWA̲NA.indb 23 00Book̲C3607DWA̲NA.indb 23
Table 5
Battery Remaining Power
(2) When the base is not inclined, use the right side of the
notch.
If the base is inclined (45 degrees), use the left side of
the notch (Fig. 27).
45° guide 90° guide
notch notch
45° 90°
Inner guide notches
Fig. 27
NOTE
When using the saw at the inclination of 45 degrees,
use both the marks of on the bevel plate and [45] on
the inclined gauge of the base (Fig. 28).
What's more, if it is absolutely essential to use the
saw at a precise angle, make adjustment using a
protractor, etc.
Bevel
plate
Inclined gauge
Fig. 28
English
Base
Incline lever
23
2021/06/10 16:51:44 2021/06/10 16:51:44