Publicité
Les langues disponibles
Les langues disponibles
WARNING
If the cutting depth lever is loose, injury can
result. Tighten it securely after adjustment.
To adjust cutting depth, loosen the cutting depth lever
and, while holding the base with one hand, move
the main body up and down to obtain the prescribed
cutting depth. After adjusting to the prescribed cutting
depth, tighten the cutting depth lever securely.
NOTE
The scale on the side of the base is accurate only with
the maximum cutting depth.
2. Adjusting the angle of inclination
WARNING
If the incline lever is loose, injury can result.
Tighten it securely after adjustment.
You can incline saw blade from 0° to a maximum
angle of 53° in relation to the base.
As shown in Fig. 22 by loosing the incline lever on the
bevel scale, the saw blade may be inclined to an angle
of 45° in relation to the base.
If you use inclination angle of over 45°, as shown in
Fig. 23 move the incline lever to outside, the saw
blade may be inclined to a maximum angle of 53° in
relation to the base.
Always ensure that the incline lever is thoroughly
tightened after making the desired adjustment.
Incline lever
0°–45°
00Book̲C3607DWA̲NA.indb 21
00Book̲C3607DWA̲NA.indb 21
Fig. 22
Incline lever
45°–53°
Fig. 23
3. 90° (0°) Bevel adjustment (Fig. 24)
WARNING
To ensure accurate cuts, alignment should be
checked and adjustments made prior to use.
Base
Fig. 24
(1) Lift the incline lever to set the saw to 90° (0°) and then
tighten the lever.
(2) Retract the lower guard and place the saw upside
down.
(3) Place a combination square against the blade and
base to check whether the blade is 90° to the base.
(4) If the blade is not 90° to the base, turn the hex screw
on the bottom of the base by using 3 mm hex wrench
to adjust.
(5) Check the accuracy of the adjustment by an actual cut
on a scrap piece of material.
English
Hex screw
Incline lever
21
2021/06/10 16:51:44
2021/06/10 16:51:44
Publicité
