Connecting To The Effector And Output Connectors; Midi Connectors - Pioneer DJM-1000 Mode D'emploi

CONNECTING TO THE EFFECTOR AND OUTPUT CONNECTORS

Master output
There is an XLR plug correspondent balanced output MASTER 1,
and a RCA plug correspondent unbalanced output MASTER 2. Set
the output level using the MASTER ATT. dial to match the input
sensitivity of the connected power amplifier.
Booth monitor output
Unbalanced output supporting Ø6.3 mm phone plug. Volume can
be adjusted with the BOOTH MONITOR dial (LEVEL), regardless of
the setting of the MASTER fader.
Recording output
Output connectors for recording, supports RCA plug.
Digital output
Coaxial digital output connector, supports RCA plug. Sampling
frequency can be selected (96 kHz/48 kHz) in accordance with
connected device.
Power amplifier
(RCA plug input connector)
MASTER
R L
OUTPUT
3
COLD
2
GND
HOT
POWER
OFF ON
L
MASTER 1
R
AC IN
DIGITAL OUT
fs(Hz)
48k 96k
48k/96k
Power amplifier
(XLR plug input
connector)

MIDI CONNECTORS

MIDI (Musical Instrument Digital Interface) is a unified standard for transmitting data between electrical musical instruments and
computers.
Data can be transmitted between devices with MIDI connectors using a MIDI cable.
The DJM-1000 can send operating data to external MIDI devices using the MIDI protocol.
DJM-1000 control
Cross fader operation
* 0-127 MIDI data is output by operating the cross fader.
* When using the visual link function, MIDI data is not output.
Cassette deck, etc.
(analog input recording device)
ATT.
L R
SIGNAL GND.
MASTER ATT.
6 5
0dB
1
–3dB
–6dB
PHONO CD / LINE PHONO CD / LINE
–12dB
REC
MASTER 2
L L
L
R R
R
L
BOOTH
(TRS)
SUBMIC SUBMIC
R
CONTROL DIGITAL CONTROL DIGITAL
Digital input AV amplifier
(Digital input
recording device)
MIDI control code
CC11
External effector
Use a cable with Ø6.3 mm phone plugs to connect the DJ mixer's
SEND connectors to the input connectors of an external effector.
When using a monaural input effector, connect only the L channel
output. In this way, the mixed L/R audio signal will be sent to the
effector.
In the same way, use a cable with Ø6.3 mm phone plugs to
connect the DJ mixer's RETURN connectors to the output
connectors of the external effector.
When the effector has only monaural output, connect the L
channel input only. In this way, the signal from the effector will be
input to both L/R channels.
INPUT
SIGNAL GND.
4 3 2
PHONO CD / LINE PHONO CD / LINE PHONO CD / LINE
L L
R R
L L L
(MONO) (MONO) (MONO)
LINE LINE LINE
R R R
CONTROL DIGITAL CONTROL DIGITAL CONTROL SOUND 2
Power amplifier
(For booth monitor)
MIDI control name
Expression
BEFORE USING (CONNECTIONS)
External effector (2)
SIGNAL GND.
1
2 SEND 1
PHONO CD / LINE
L
MIDI OUT
(MONO)
L L
R
R R
L
L
(MONO)
(MONO)
VISUAL
LINE
R
R
2 RETURN 1
EFX 2 EFX 1
CONTROL SOUND 1
External effector (1)
MIDI Channel
1
7
<DRB1372>
En