SOLAC AE2510 Mode D'emploi page 12

Uncharge the batteries completely now and then for maximum
performance.
3 USER INSTRUCTIONS
1 Insert the handle (1) in the opening on the main body of the broom (3)
and fasten both parts together by tightening the fastening screw (15) with
a coin. (Fig. 2).
2 Make sure the dust canister (6) and filters (9 and 10) are installed
correctly. See the section titled Cleaning the dust canister and filters.
3 Insert the multi-purpose brush (11) into the suction nozzle and press it in
until you hear a click. To remove the brush, gently press the multi-
purpose connection/disconnection button (12) and pull it out. (Fig. 3).
The multi-purpose brush (11) is ideal for vacuuming all kinds of floors,
carpets and rugs.
4 To turn the broom on, slide the on/off button (2) down.
5 Once you have finished cleaning, turn the broom off by sliding the on/off
button (2) up.
Important: After each use, place the broom on the charger (13) to keep
the suction power at peak level. This makes sure the battery is fully
charged ready for the next time it is used.
CLEANING THE DUST CANISTER AND FILTERS
Befote starting to clean and maintain the appliance, make sure you have
unplugged the appliance.
When the dust stored in the canister reaches the maximum level mark
(8), you should empty the canister. To ensure the continued top-quality
performance of your appliance, we recommend cleaning the canister
and filters after each use.
When you need to empty the dust canister, disconnect the appliance and
proceed as follows:
1 Press the canister removal button (7) upwards and remove the canister.
(Fig. 4).
2 Remove the filter (10) by holding the canister and pulling the filter tab
out. (Fig. 5). Shake the filter out in the rubbish bin or use a brush to clean
it.
3 Remove the protection filter (9) by pulling it upwards. (Fig. 6). Shake the
filter out in the rubbish bin, banging it lightly against the sides of the bin
until no more dust falls off.
12 USER INSTRUCTIONS