Designated Use; Intended Purpose; Technical Data; Equipment - Clipster FarmClipper4 Mode D'emploi

2. Designated use

2.1 Intended purpose

n and The clipper is exclusively intended for clipping cattle, horses or large dogs. Any other use, in particular on humans, is
nstruc- explicitly prohibited.

2.2 Technical data

Type designation:
Supply voltage:
Motor rating:
Frequency:
Dimensions (W/H/L):
or a Weight without cable:
regu- Sound pressure level:
vised Strokes:
ot store Protection class:
Operating conditions
Max. ambient temperature:
Max. air humidity:
defective

2.3 Equipment

1 clipper with clipper head, 1 set of shear blades (mounted), (100 ml), 1 screwdriver, 1 operating manual and
1 storage case
uropean

3. Initial commissioning

3.1 Inspection and operating instructions

The inappropriate use of electrical devices, in particular animal breeding devices, is dangerous! Therefore, observe the
following, accident prevention measures before starting the machine: • Never switch the machine on without properly
mounted clipping plates • The volt specification on the rating plate must correspond to the mains voltage. The machine
may only be operated with AC • Avoid any contact with the moving blades • Always pull the power supply plug out
prior to maintenance work! Do not touch the blade area, even if the machine is switched off, as long as the machine is
connected to the current supply • Always place machine on a dry surface and store in dry rooms • Avoid any contact
clipper.
with a machine, which is in contact with liquids. Never clip wet animals. Liquids that have penetrated into the machine
reduce the electrical insulation. There is the imminent danger of an electric shock or short-circuit. Only clean the
machine with a dry cloth and a paint-brush or brush • A cable lying on the floor can get caught and be dangerous. Lay
the cable carefully and safely before clipping. Prevent the clipper connection cable from kinking or tangling. Ensure that
animals do not stand on the cable, walk over it or get caught. Keep the cable away from hot surfaces. Never wind the
cable around the machine. This can result in insulation damage and cable break. Examine the cable regularly for de-
fects • Set the machine switch to off (fig. 3) before pulling the plug from the mains • Do not use damaged shear blades
with broken off teeth. Only use sharp shear blades. Only use the original shear blades. • Never insert an item into an
opening of the machine. The machine noise can disturb animals. A kick or the weight of the animal can result in sub-
stantial injuries. Therefore fixate the animal sufficiently. • Animals should only be clipped, when unauthorised persons
do not have access to the clipping location • Only clip in well-ventilated rooms and never in the proximity of explosive
materials. These safety notes must be observed in all cases!

3.2 Blade adjustment with the tension screw

Adjust as follows when placing into operation:
Prior to clipping: Turn the tension screw up to the first noticeable resistance with the machine switched off. Then con-
tinue to turn the tension screw by a further 1/4 rotation.
18192=BA_FarmClipper4_Clipster_148x210_1018.indd 17
18192
220 – 240 V AC
200 W
50/60 Hz
80 x 62 x 295 mm
1190 g
85 dB (A)
3000/ min
II
0 – 40° C
10 – 90 % (relative)
17
19.10.2018 11:55:02