Resharpening The Blades; Storing The Clipper; Cleaning The Clipper Head; Repairs - Clipster FarmClipper4 Mode D'emploi

The

4.3 Resharpening the blades

on. Resharpening shear blades correctly is only possible with special machines and by the specialised trade. Only use sharp
f you shear blades. Defective blades with broken off teeth or blunt blades must be replaced.
le! The
d too

4.4 Storing the clipper

clipping. Between clippings always keep the well-cleaned and lubricated clipper in the supplied case in a dry location, which is
not accessible to children. Do not switch the machine on, if you suspect that liquids could have entered. There is danger
of an electric shock or short-circuit. Have the machine serviced!
ubricati-
e life of

4.5 Cleaning the clipper head

on the Clean the clipper head after a few days use. Dismantle the cutter plates. Release both screws and remove
the clipper head from the drive unit. Now clean the interior of the clipper head and the other components thoroughly
with a brush and a paintbrush. Lubricate the clipper head according to 3.3 after careful assembly.

5. Repairs

5.1 Introduction

ning the
You can read up on troubleshooting measures on the next page. Only authorised technical personnel may carry out
troubleshooting measures marked with an *.
5.2 Malfunction lists
Contact an authorised service department to repair not listed malfunctions.
e power
hine is

6. Environmental protection and disposal

remove
rust
on that
ook
irt-free;
18192=BA_FarmClipper4_Clipster_148x210_1018.indd 19
The user is responsible for the appropriate disposal of the shear blades and clipper after their service
life. Observe your local pertinent regulations. Do not dispose of the appliance with domestic refuse.
As part of the EU Directive governing the disposal of electric and electronic appliances, the appliance
is accepted free of charge by local waste collection points or recycling centers. Correct disposal will
ensure environment protection and prevent a potential harmful impact on people and the environ-
ment.
19
19.10.2018 11:55:02