Correct Clipper Head Oiling; Turning On/Off; Maintenance; Cleaning - Clipster FarmClipper4 Mode D'emploi

During clipping: Reset the tension screw by a further quarter-turn, if the blades do not cut sufficiently anymore. The
blades are blunt and must be resharpened, if resetting is unsuccessful. Be careful not to overdo the clipping tension.
Slightly reset the clipping tension occasionally during clipping. Hairs can accumulate between the shear blades, if you
clip with insufficient clipping tension. This negatively influences the clipping procedure or even makes it impossible! The
shear blades must be disassembled, cleaned, oiled and reassembled according to item 4.2 if this is the case. Avoid too
high plate pressure, since this increases temperature and wear. The factory has fully adjusted shipped shears for clipping.

3.3 Correct clipper head oiling

The most frequent error cause for a non-satisfactory clipping result as well heating up of the clipper is want of lubricati-
on. A light oil film on the shear blades is essential for an optimal clipping result as well as to increase the service life of
the shear blades and machine. All other moving parts of the clipper head must also be well lubricated. Drip oil on the
shear blades and into the oil opening of the clipper head
(fig. 1 + 2) every 10 minutes, so that these do not run dry. Only use our special clipper machine oil.

3.4 Turning on/off

The slide switch has two positions (fig. 3, shows position 0)
• Position 1: Machine is turned on
• Position 0: Machine is turned off
Check the switch position before plugging in. The switch must be in position 0. Only use the slide switch for turning the
machine on and off.

4. Maintenance

Turn the machine off and pull the power supply plug before beginning maintenance work. Always disconnect the power
supply first before working on the shear blades/clipper head. Do not touch the shear blade area even if the machine is
switched off as long as the clipper is still connected to the current supply.

4.1 Cleaning

After having finished clipping wipe the oil off the machine, clipping head and shear blades with a dry cloth and remove
the hairs with a dry paintbrush or brush. Then lightly oil all parts to prevent rusting. Note that even the smallest rust
spots impair clipping considerably or even render this completely impossible.

4.2 Shear blade assembly

The shear blade set consists of a lower plate and an upper plate. When assembling the shear blades pay attention that
the correct plates lie on top of one another.
Assemble the blades as follows:
• Loosen the clipper tension screw and put the clipper onto a hard surface, so that the blade fastening screws look
upwards.
• Loosen the blade fastening screws and remove the two old blades.
• Ensure that the new shear blades are clean. Pay particular attention to the fact that the sharpened areas are dirt-free;
it is otherwise impossible to achieve a satisfactory clipping result even with newly sharpened shear blades.
• Put the new upper plate into the swing head guides and then put some drops of oil onto the sharpened areas.
• Now push the new lower plate in between the released screws (fig. 4).
• As soon as you have adjusted the shear blades, fixate the lower plate position and tighten the blade
fastening screws.
18192=BA_FarmClipper4_Clipster_148x210_1018.indd 18
18
4.3 Res
Resharp
shear bl
4.4 Stor
Between
not acce
of an ele
4.5 Clea
Clean th
the clipp
with a b
5. Re
5.1 Intr
You can
troubles
5.2 Mal
Contact
6. En
19.10.2018 11:55:02