Publicité
Les langues disponibles
Les langues disponibles
–
Pull out the drain channel from the freezer cabinet, turn it 180° and
secure it (see diagram). Place a suitable container underneath the
channel outlet.
–
Leave the freezer door open.
–
To accelerate defrosting, one or several containers with hot (but not boiling) water may be placed
inside the freezer.
–
Do not pour water over or inside the unit
–
Warning: Do not use any external device or other means (e.g. heaters or heating fans) to
accelerate de-frosting.
–
For frequent cleaning we recommend the use of warm water with some mild detergent. Any
accessories should be cleaned separately with soapy water. Do not put them in a dishwasher.
–
Do not use abrasives or harsh cleaning solutions or any cleaning agents that contain alcohol.
–
After cleaning, thoroughly clean all surfaces again with fresh water before wiping them
completely dry.
–
Slide the drain channel back in and replace the covering panel.
–
When re-inserting the plug into the wall socket ensure that you have dry hands.
–
Turn the temperature control to its maximum setting. After 24 hours, the temperature control
can be returned to its normal setting.
–
Take care not to remove or damage the rating plate inside the cabinet during cleaning.
–
To save energy, the condenser and the compressor (at the rear) should be cleaned carefully at
least twice a year with a hand-brush or a vacuum cleaner.
Trouble-shooting
Certain typical sounds can be heard when the appliance is switched on. These sounds are:
–
caused by the electrical motor within the compressor assembly;
during compressor start-up the sound level will be slightly higher
for a limited period of time.
–
caused by the cooling agent flowing through the circuit.
The following table lists possible malfunctions and their probable causes and solutions. In the event
of operational problems, check first whether a solution can be found using this table. If the problem
persists, disconnect the appliance from the mains power and contact our Customer Service
Department.
Problem
The appliance is not working
at all.
Possible cause and solution
–
There is a power failure
–
The main fuse has blown.
–
The temperature control is set to '0'.
–
The fuse in the wall socket (if applicable) has blown. This can
be checked by connecting another electrical device to the
socket and checking for function.
23
Publicité
