Preparation; Dismantling The Case; Installation Of The Compression Seal; Assembly Procedure - ADEUNIS ARF8230AA Guide Utilisateur

LoRaWAN 863-870 Pulse - Guide utilisateur / User guide version V2.0.0
5.

PREPARATION

5.1. Dismantling the case

The product is supplied disassembled such that the lower electronic part can be accessed. This part is
where the meter or meters are connected to the screw terminals and where the configuration switches
can be accessed.
Once connection of the meters has been finalized and configuration carried out, the case may be
closed.
Please note: once the case has been closed, opening it is no longer possible without the risk of losing
the IP67 protection index guarantee.

5.2. Installation of the compression seal

Before connecting your meter cables to the product's screw terminals, you must insert the compression
gland nut and the appropriate seal for your configuration.
3 types of seals are supplied with the PULSE: for a 5 mm diameter cable, for a 3 mm diameter cable,
for 2 x 2.2 mm cables.
Seal for 1 x 5 mm cable

Assembly procedure:

1 - Your meter 2 - Pass the
and its pulse cable through
interface. the compres-
sion gland nut.
Seal for 1 x 3 mm Seal for 2 x 2.2 mm
cable cables
90
3 - Pass the 4 - Pass the ca-
cable through ble through the
105
the compression PULSE'S case
gland seal plate.
27
5 - Install the 6 - Connect
O-ring seal on the ends of
the case plate. the meter
cable to the
screw termi-
nals.
Page
FR
EN
97 of 108