Product Operation; Global Operation; Park Mode; Command Mode - ADEUNIS ARF8230AA Guide Utilisateur

LoRaWAN 863-870 Pulse - Guide utilisateur / User guide version V2.0.0
2.

PRODUCT OPERATION

2.1. Global Operation

Important: adeunis® use the most significant byte first format.
The product has several operating modes:
Command send-
ing by serial link
COMMAND
MODE
2.1.1

PARK mode

The product is delivered in PARK mode, it is in standby mode and its consumption is minimal. To switch
the product out of the Park* Mode pass a magnet across it for a duration higher than 6 seconds. The
green LED illuminates to indicate the detection of the magnet and then flashes quickly during the prod-
uct starting phase.
The device then sends its configuration and data frames (see paragraph 4.1).
2.1.2

COMMAND mode

This mode allows the user to configure the registers of the product.
To enter this mode, connect a cable to the micro-USB port of the product and enter the command
mode by an AT command (see paragraph 3).
2.1.3

OPERATING mode

There are two possible modes of operation:
• TEST mode:
This mode allows the user to perform tests of the product more quickly by reducing the time scales
of production mode and modifying the behavior of the LEDs (see paragraph 2.2.5). WARNING : this
mode has an highly impact on the device autonomy
• PRODUCTION mode:
This mode allows the user to operate the product in its final use. It should allow a maximum of autono-
my to the product.
To switch from one mode to the other the user changes the value of a register
PARK MODE
OPERATING
MODE
REPLI MODE
PRODUCTION
MODE
COMMAND
MODE
TEST MODE
Presence of a magnet on
the product >6s
Presence of a magnet
on the product >6s
Automatic if bat-
tery too low
*Only on changeable battery ver-
sion, on request
The return to the
production mode
is done by the ATO
command or by
disconnecting the
COMMAND
USB cable.
MODE
FR
EN
*Replacing the
battery
Page 67 of 108