ROOTPAR6
STANDALONE MODE LOOP (Loop 1–4)
Dimmer
Sets brightness
Step time
Sets step time
Fade time
Sets fade time in percent
Delay
Delay time for slave groups
1st step
15 colors from Color Preset
4 colors from User Color
UV light
Blackout
2nd step
3rd step
15 colors from Color Preset
4 colors from User Color
UV light
Blackout
-------
4th step
SLAVE MODE
Standard slave mode: Starting from the main display, press MODE to enter the main menu. Now use UP and DOWN to select the menu
item Slave, confirm with ENTER, select Slave Group 0 and again confirm with ENTER. Connect the slave and the master units (same model,
same software version) using a DMX cable, and enable one of the standalone modes on the master unit (Auto, Static, Color Preset, User
Color, Loop). The slave unit will now exactly follow the master unit.
--------Menu-------
----Slave Group----
DMX Address
Standalone
0
DMX Mode
Slave
DMX Delay
Settings
Standalone
Slave
Settings
System Info
Advanced slave mode: If, in master/slave mode, you would like to control the slave units via one of the standalone modes Auto or
Loop, the control signal can be passed on with a delay in up to 15 steps (ROOTPAR4: Slave Group 1–15, ROOTPAR6: 1–13). The delay is
defined in the submenu item Delay in the respective standalone mode and the delay factor in the slave menu of the corresponding spotlight.
This is a simple way to create a running light effect with a large number of spotlights that are all the same model and which are all
running the same software version. This is otherwise only realisable with a suitable DMX controller and time-consuming programming.
CLROOTPAR4
--------Menu-------
----Slave Group----
DMX Address
DMX Mode
Standalone
1–15
DMX Delay
Slave
Standalone
Settings
Slave
Settings
System Info
Assign the spotlights to one of up to 15 groups as desired (ROOTPAR4: Slave Group 1-15, ROOTPAR6: 1-13). Multiple spotlights may be
assigned to a group. The group number is also the factor by which the delay time set in the master unit is multiplied (see setup example).
Red to CW (Cold White)
User 1 to User 4
"
Red to CW (Cold White)
User 1 to User 4
"
Mode
Slave
Main display
CLROOTPAR6
----Slave Group----
Mode
Gr 1
Standalone
Slave
1–13
Slave
Settings
Main display
with group number
and delay time in
master unit
0–100
0.1 s to 10.0 s
0% to 100%
0.0 s to 2.0 s
UV
Blackout
"
UV
Blackout
Skip step
"
2.0
s
13