Slave Mode - Cameo ROOT PAR TW Manuel D'utilisation

1st step 4 presets with various color temperatures
2nd step 4 presets with various color temperatures plus blackout

SLAVE MODE

Standard Slave mode: Starting from the main display, press MODE to go to the main menu. Using UP and DOWN, now select the Slave
menu option, press ENTER to confirm, then select Slave Group 0, and select ENTER once again to confirm. Connect the slave and master
unit (same model, same software version) using a DMX cable, and activate one of the stand-alone modes (Direct, CCT, Loop) on the master
unit. The slave unit will now follow the master unit precisely.
Advanced slave mode: In the advanced master/slave mode, the control signal can be reproduced with a time delay of up to 15 levels. The
delay time is set on the master unit in the Delay submenu option in the stand-alone mode Loop and the delay factor for the corresponding
slave unit in the slave menu. This allows a chaser light effect to be easily created with any number of spotlights of the same model and
software version, which could otherwise only be achieved with a suitable DMX controller and complex programming.
Assign the slave units to one of up to 15 groups as required. Several slave units can also be assigned to one group. The group number is
also the factor by which the set delay time on the master unit is multiplied (see setup examples).
10
Main display
Main display with group number plus
delay time of the master unit
Hal (Halogen)
Neu (Neutral)
Stu (Studio)
Day (Daylight)
Hal (Halogen)
Neu (Neutral)
Stu (Studio)
Day (Daylight)
Black (Blackout)