Setting Up And Connecting The Appliance - Dometic MaCave A25G Notice D'utilisation

MaCave
Control elements
No. in
fig. 2, Symbol Description
page 3
1 I/O
2
3
4
5
6 –
7 Setting up and connecting the
appliance
7.1 Notes on setting up the appliance
The wine refrigerators can be set us as free-standing installations.
When selecting the location, observe the following instructions:
 The ambient temperature should lie within the range of the climate class.
Otherwise, it could mean that the inner temperature you set cannot be
reached or maintained. This could also be the case if there are extreme
fluctuations in the ambient temperature.
 The appliance should stand in the coldest part of the room, away from
heat sources (ovens, heating devices or radiators).
 The location must not be damp or wet.
 The appliance must not be exposed to direct sunlight. This can damage
the acrylic coating and lead to higher power consumption.
 The ground must be level and sufficiently stable to bear the wine cellar at
full capacity.
 The appliance must be sufficiently ventilated. Set up the device so that
minimum distances of 50 mm from the side walls and 100 mm from the
rear walls are adhered to (fig. 3, page 4). The ventilation slots on the top
of the device must not be obstructed.
EN

Setting up and connecting the appliance

On/off switch
Lowers the set temperature by 1 °C or 1 °C
Increases the set temperature by 1 °C or 1 °C
Cooling mode
Heating mode (A192G/A192D)
Display, indicates the current temperature
29