Initial Use; Setting The Alarm - Beurer WL 32 Mode D'emploi

5. Initial use

• Remove the packaging material.
• Check that all parts listed are present.
• Check the device, mains adapter and mains cable for
damage.
• Remove the battery compartment lid on the underside of
the device and insert the batteries with the correct polar-
ity. The batteries supply power to the device in the event
of a power failure.
• Place the device on a firm, even surface.
• Insert the mains adapter connector into the mains adapter
socket on the rear of the device.
• Insert the mains adapter into a suitable socket. The time
is shown on the device display.
Note
• If you would like to reset the device to the factory set-
tings, press in the reset button on the underside of the
device using a pointed object.
6. Operation
Note
The device exits the settings menu automatically if no but-
ton is pressed for 10 seconds.
6.1 Setting the time and snooze duration
• Press the button.
The time will start to flash.
Using the /buttons, select the desired time.
Note
To navigate through the hours or minutes more quickly,
press and hold the /button.
• Confirm the selected time with the
"24 Hr" now flashes on the display.
You can now choose between 12 and 24-hour format.
• Using the /buttons, select the desired hour format
and confirm with the
"Zz 05" now flashes on the display.
• Using the /buttons, select the desired snooze dura-
tion (5-60 minutes) and confirm with the

6.2 Setting the alarm

You can set two separate alarm times (alarm 1 and alarm 2)
on the wake-up light.
• To set alarm 1, press the
• To set alarm 2, press the
The corresponding alarm time starts to flash on the display.
• Using the /buttons, set the desired alarm time.
• Using the button, select your desired alarm sound
for this alarm time.
You can choose between radio ( ) and a beep (
• Confirm using the
16
button.
button.
button.
button once.
button twice.
button.
).