Mounting The Bar And Chain - Stihl HTA 65 Notice D'emploi

Chain Scabbard
The scope of supply includes a bar
scabbard that matches the cutting
attachment.
If guide bars of different lengths are
mounted to the pole pruner, always use
a chain scabbard of the correct length
which covers the complete guide bar.
The length of the matching guide bars is
marked on the side of the chain
scabbard.
HTA 65, HTA 85

Mounting the Bar and Chain

Removing the chain sprocket cover
Unscrew the nut and remove the
N
cover.
1
2
Turn the screw (1)
N
counterclockwise until the tensioner
slide (2) butts against the left end of
the housing slot, then back it off 5
full turns.
Fitting the chain
WARNING
Wear work gloves to protect your hands
from the sharp cutters.
Fit the chain – start at the bar nose.
N
English
49