Mounting The Barrier Bar; Mounting And Removing The Deflector - Stihl FSA 90 Notice D'emploi

7 Assembling the Trimmer
► Insert the screws (1) through holes in the loop handle (3)
and clamps (4 and 6).
► Fit and tighten down the nuts (7) firmly.
7.2

Mounting the Barrier Bar

The barrier bar can only be mounted in combination with the
loop handle.
► Switch off the trimmer, push retaining latch to position
and remove the battery.
1
► Insert nuts (2) in the barrier bar (1) so that the holes line
up.
► Fit the clamp (5) in the loop handle (3).
► Place the loop handle (3) with clamp (5) and barrier bar (4)
on the drive tube (6).
► Hold the clamp (7) against the drive tube (6).
► Insert and tighten down the screws (8) firmly.
7.3

Mounting and Removing the Deflector

7.3.1 Mounting the Deflector
► Switch off the trimmer, push retaining latch to position
and remove the battery.
0458-709-9621-C
3 4
2
5
6
7
8
1
2
The line limiting blade (1) is already installed in the deflector
(2) and must not be removed.
► Push the deflector (2) into the guides on the housing as far
as stop.
The deflector (2) is tight against the housing.
► Insert and tighten down the screws (3) firmly.
7.3.2 Removing the Deflector
► Switch off the trimmer, push retaining latch to position
and remove the battery.
1
► Take out the screws (2).
► Pull off the deflector (1).
English
3
2
2
53