Stihl HTA 65 Notice D'emploi page 45

Accessories and Spare Parts
Only use tools, guide bars, chains, chain
sprockets and accessories that are
explicitly approved for this power tool
model by STIHL or are technically
identical. If you have any questions in
this respect, consult a servicing dealer.
Use only high quality tools and
accessories in order to avoid the risk of
accidents and damage to the unit.
STIHL recommends the use of genuine
STIHL tools, guide bars, chains, chain
sprockets and accessories. They are
specifically designed to match the
product and meet your performance
requirements.
The Drive Unit
Battery
Observe the information in the leaflet or
instruction manual supplied with the
STIHL battery and keep it in a safe
place.
For further notes on safety see
www.stihl.com/safety-data-sheets
Charger
Observe the information in the leaflet
supplied with the STIHL charger and
keep it in a safe place.
Notes on Operation
Remove the battery from
the power tool:
HTA 65, HTA 85
before carrying out inspections,
–
adjustments or cleaning work
when working on the cutting
–
attachment
before leaving the machine
–
unattended
before transporting the machine
–
before storing the machine
–
before performing repairs and
–
maintenance work
in the event of danger or in an
–
emergency
This avoids the risk of the motor starting
unintentionally.
Before Starting Work
Check that your power tool is properly
assembled and in good condition – refer
to appropriate chapters in the instruction
manual.
Correctly mounted guide bar
–
Correctly tensioned chain
–
The trigger switch and trigger
–
lockout must move freely (retaining
latch to ‚) – switches must return to
the idle position when they are
released.
Trigger is locked in position when
–
trigger lockout is not depressed.
Never attempt to modify the controls
–
or safety devices in any way.
Keep the handles dry and clean –
–
free from oil and dirt – for safe
control of the power tool.
Inspect the power tool for damage
–
or wear. Always replace damaged
parts.
Check contacts in battery
–
compartment for foreign matter.
Fit the battery correctly – it must
–
engage audibly.
Never use defective or deformed
–
batteries.
To reduce the risk of accidents, do not
operate the unit if it is not properly
assembled and in good condition.
If you use a shoulder strap or full
harness: Practice removing and putting
down the power tool as you would in an
emergency. To avoid damage, do not
throw the power tool to the ground when
practicing.
Switching on the machine
Place the unit on a firm surface. Make
sure you have good balance and secure
footing. Hold the unit securely. The
chain must be clear of the ground and all
other obstructions.
Your power tool is designed to be
operated by one person only. Do not
allow other persons in the work area.
Do not switch on the power tool when
the saw chain is in a cut.
During Operation
Make sure you always have good
balance and secure footing.
In case of imminent danger or in an
emergency, switch off the power tool
immediately, move retaining latch to ƒ
and remove the battery.
Your power tool is equipped with a
system designed to quickly stop the saw
chain – it comes to an immediate
standstill as soon as you release the
trigger switch.
English
43