Sennheiser Esfera SPB 8000 Notice D'emploi page 28

Connecting the SPB 8000 to a computer
Connecting the SPB 8000 to a computer
You can adjust the presets of the SPB 8000 using a configuration software. To allow for this,
the SPB 8000 has to be connected to a computer.
Use the supplied network cable to connect the network socket
network socket of a computer.
Calling up the configuration software and working with
presets
The configuration software can be found at www.sennheiser.com/spb-8000.
The SPB 8000 processing unit is delivered with the IP address set to 192.168.1.75.
Make sure that your computer uses the same IP subnet as the SPB 8000 (e.g. IP address:
192.168.1.74, subnet mask: 255.255.255.0).
Start the configuration software.
After installation, the user interface of the configuration software appears:
10 | SPB 8000
0
of the SPB 8000 to the