Operation Without The Remote Control Unit; Care And Cleaning - Technibel Climatisation MCA 45C Notice D'utilisation

Air outlet
EG
grille
Sweep function
The flap starts moving up and down to deliver air
over the sweep range.
Setting the Airflow Manually
Referring to the above illustration, use the FLAP button
to set the airflow direction within the range used during
the heating, cooling, or dehumidifying operation
• The flap automatically closes when the unit is off.
NOTES
• During the heating operation, the fan speed
will be very low and the flap will be in the
horizontal position (position 6 ) until the air
being blown out of the unit begins to warm.
Once the air warms up, the flap position and
fan speed change to the settings specified
with the remote control.
CAUTION
• Use the FLAP button on the remote control to adjust
the position of the flap. If you move the flap by hand,
the factual flap position and the flap position on the
remote control may no longer match. If this should
happen, shut off the unit, wait for the flap to close,
and then turn on the unit again; the flap position will
now be normal again.
• Do not have the flap pointed down during cooling
operation. Condensation may begin to form around the
air vent and drip down.
Up
Flap
Down
6
5
SWEEP
COOL and DRY
SWEEP
HEAT
OPERATION WITHOUT THE REMOTE
CONTROL UNIT
If you have lost the remote control unit or it has troubles, follow
the steps below.
1. WHEN THE AIR CONDITIONER IS STOPPED
If you want to turn on the air conditioner, switch the operation
selector to the OFF position, and then to the ON position.
NOTE
The set temperature, and fan speed are automatically set at
the last selection before stopping.
2. WHEN THE AIR CONDITIONER IS RUNNING
If you want to turn off the air conditioner, switch the OPERATION
SELECTOR TO the OFF position.
NOTE
Power failure during operation.
In the event of power failure, the unit will stop. When the power
is resumed, the unit will restart automatically after 3 minutes.
4
3
2
1

CARE AND CLEANING

For safety, be sure to turn the air conditioner off and also to
disconnect the power before cleaning.
Do not pour water on the indoor unit to clean it. This will damage
the internal components and cause an electric shock hazard.
CASING AND GRILLE (INDOOR UNIT)
Clean the casing and grille of the indoor unit with a vacuum cleaner
brush, or wipe them with a clean, soft cloth.
If these parts are stained, use a clean cloth moistened with a mild
liquid detergent.
When cleaning the grille, be careful not to force the vanes out of
place.
The air intake grille can be removed in order to wash it with water.
The air intake grille can be removed in order to wash it with water.
Removing and remounting tha air intake grille
• With the air intake grille open all the way, grip both arms with your
hans and pull toward you to remove.
• To remount, hold the air intake
grille roughly horizontal and
push it in until the arm shafts fit
into the indentations in the main
unit, then fit the grille into place.
Washing the grille with water
• Clean the grille gently using a
soft sponge, or the like. Then
wipe away any remaining
moisture.
• Neutral detergent may be used to remove stubborn dirt. Then
rinse thoroughly with water and wipe away any remaining
moisture.
CAUTION
Never use solvents, or harsh chemicals when cleaning the indoor
unit. Do not wipe the plastic casing using very hot water.
Some metal edges and the vanes are sharp and may cause
injury if handled improperly; be especially careful when you
clean these parts.
The internal coil and other components of the outdoor unit must
be cleaned every year. Consult your dealer or service centre.
10
WARNING
Operation
selector
Air intake grille
Arm