Technical Data - Scheppach LB2500P Traduction Des Instructions D'origine

Safety of persons
Be careful, watch what you are doing and use an
•
device sensibly. Do not use the tool if you are tired
or under the influence of drugs, alcohol or medica-
tion. A moment of inattention when using the device
can result in serious injuries.
Wear personal protection equipment and always
•
wear safety goggles. Wearing personal protection
(such as dust masks, non­slip safety shoes, safety
helmet or ear protection, depending upon the type
and use of the device) reduces the risk of injury.
Make sure that the appliance cannot start up ac-
•
cidentally. If your finger is on the switch whilst car-
rying the device this can lead to accidents.
Remove keys and wrenches before switching on
•
the device. A tool or key which comes into contact
with rotating parts of the appliance can lead to
injuries.
Avoid abnormal working postures. Make sure you
•
stand squarely and keep your balance at all times.
In this way, you can control the device better in
unexpected circumstances.
Wear suitable work clothes. Do not wear loose
•
clothing or jewellery. Keep hair, clothes and gloves
away from moving parts. Loose clothing, jewellery
or long hair can get trapped in moving parts.
Usage and treatment of the device
Do not overload the appliance. Use the correct
•
tool for your work. You will be able to work bet-
ter and more safely within the given performance
boundaries.
Do not use an device with a defective switch. An
•
device tool that cannot be switched on or off is
dangerous and must be repaired.
Keep unused device out of the reach of children.
•
Do not allow people who are not familiar with the
appliance or who have not read these instructions
to use the appliance. Device are dangerous if they
are used by inexperienced people.
Clean your device carefully. Check whether moving
•
parts are functioning properly and not jamming,
whether parts are broken or damaged enough that
the functioning of thisdevice is affected. Have dam-
aged parts repaired before using the appliance.
Many accidents are caused by badly maintained
device.
Make sure to use device, accessories, attach-
•
ments, etc. in accordance with these instructions.
Take the conditions in your work area and the job
in hand into account. Using device for any purpose
other than the one for which they are intended can
lead to dangerous situations.
Safe handling with fuels
Fuels and fuel vapours are inflammable and may
cause serious injury on the skin or when inhaled.
Therefore be careful and provide sufficient ventilation
when handling with fuels.
Stop the engine and allow the device to cool down
•
before fuelling it.
20 GB
Do not smoke and avoid open flames when fuel-
•
ling. (Fig.2)
Wear gloves when fuelling.
•
Do not fuel in closed rooms. (Danger of explosion)
•
Avoid spilling of fuel or oil. Clean the hedge trim-
•
mer immediately when you have spilled fuel or oil.
Change your clothes immediately when you have
spilled fuel or oil on them.
Make sure that no fuel can come into the soil.
•
Carefully close the tank cap after fuelling and
•
check that it does not get loose during operation.
Check that there is no leakage on the tank cap
•
and fuel lines. If there are leaks this device may
not be started.
Only transport and store fuels in containers ap-
•
proved and identified for this.
Keep children away from fuels.
•
Do not handle and store fuels close to combustible
•
and highly inflammable materials as well as sparks
and open flames.
Go away at least three metres from the fuelling
•
place to start the device.
To reduce the fire risk keep the motor and silencer
•
free from cutting remainders, leaves and lubricants.
Keep handles dry, clean and free of fuel mixture.
•
Do not refuel a running engine or an engine that
•
is hot.
Risidual risks
Even if used properly, residual risks can exist even if
the relevant safety regulations are complied with due
to the design determined by the intended purpose.
Observing these instructions, and taking proper care,
will reduce the risk of personal injury or damage to
theequipment.
Injury by catapulted parts.
•
Breaking or catapulting of knife pieces.
•
Carbon monoxide poisioning when using the de-
•
vice in closed or poorly ventilated rooms.
Burning when touching hot parts.
•
Impairment of hearing when working on the ma-
•
chine for longer periods of time without ear pro-
tection.
In addition, in spite of all the precautionary measures
taken, non­obvious residual risks can still exist.Re-
sidual risks can be minimised if the "Safety informa-
tion" and the "Intended usage" as well as the whole
of the operating instructions are observed.

6. Technical data

LB2500P
Technical data
Dimension LxWxH mm
Air speed max. km/h
air volume min./max. m /min
3
dust bag capacity l
Power unit
Displacement cm3
1050x250x350
268
12
-
25,4