Storage; Disposal And Recycling - Scheppach LB2500P Traduction Des Instructions D'origine

Keep all nuts, bolts and screws tight to be sure the
appliance is in safe working
condition.
• Replace worn or damaged parts.
• Use only genuine replacement parts and accesso-
ries
• Store the appliance only in a dry place.
The user is responsible for all damages caused by
non­compliance with instructions in this manual. This
also applies to non­authorized modifications of the
tool, use of non­authorized spare parts, accessories,
working tools, unrelated and not intended use, sec-
ondary damages due to use of faulty components.
Warning!
Use only original manufacturer's replacement parts,
accessories and attachments. Failure to do so can
cause poor performance, possible injury and may
void your warranty.
Important hint in case of sending the equipment
to a service station:
Due to security reasons please see to it that the
equipment is sent back free of oil and gas!
Ordering replacement parts
Please quote the following data when ordering re-
placement parts:
• Type of machine
• Article number of the machine
Service information
Please note that the following parts of this product
are subject to normal or natural wear and that the
following parts are therefore also required for use
as consumables.
Wear parts*
Spark plug
•
• Air filter
• Fuel filter
* Not necessarily included in the scope of delivery!

10. Storage

Important: Never put the equipment into storage for
longer than 30 days without carrying out the follow-
ing steps.
Storing the equipment
If you intend to store the equipment for longer than 30
days, the equipment must be prepared accordingly.
Otherwise the fuel still remaining in the carburetor
will evaporate and leave a rubbery sediment. This
can cause problems when starting up the equipment
and may require expensive repairs.
Slowly remove the fuel tank cap to release any
•
pressure that may have formed in the tank. Care-
fully empty the tank. Empty the tank only outdoors
or in well­ventilated areas. Make sure that no fuel
enters soil (environmental Protection). Use suit-
able base.
24 GB
• To remove the fuel from the carburetor, start the
engine and let it run until the equipment stops.
Leave the engine to cool (approx. 5 minutes).
•
Remove the spark plug (see section Change and
•
clean the spark plug).
• Add one teaspoon of 2­stroke engine oil into the
combustion chamber. Slowly pull the starter cord
several times to apply a layer of oil to all internal
components. Fit the spark plug again.
Note: Store the equipment in a dry place and far
away from possible ignition sources such as an oven,
a gas­fi red hot water boiler, a gas­fi red dryer, etc.
Putting the equipment back into operation
Remove the spark plug (see section Change and
•
clean the spark plug).
Quickly tug on the starter cord to remove excess
•
oil from the combustion chamber.
• Clean the spark plug and check that the electrode
gap is correct, or insert a new spark plug with the
correct electrode gap.
Prepare the equipment for operation.
•

11. Disposal and recycling

The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The equip-
ment and its accessories are made of various types
of material, such as metal and plastic. Defective
components must be disposed of as special waste.
Ask your dealer or your local council.