MELICONI AT55 White Mode D'emploi page 5

"AT52" AMPLIFIED INDOOR ANTENNA
INSTRUCTIONS FOR USE
The Meliconi AT 55 amplifi ed indoor antenna receives and amplifi es digital terrestrial TV signals
and DAB radio signals in the VHF (band III, 174 - 240 MHz) and UHF (470 - 790 MHz) bands.
• Product for indoor use only; do not use outdoors.
• Keep away from water: the device must not be exposed to drips or sprays of water. Do not
use in a damp environment.
• The product must not be exposed to excessive heat, like direct sunlight, fi re or similar heat
sources.
• Do not connect the device to any power supply other than the one it was supplied with.
• The power supply unit must be easily accessible to enable the separation of the device from
the electrical mains supply.
• In the event of a fault with the power supply, disconnect it from the electrical mains socket
immediately.
• Do not tamper with, or attempt to repair the device – danger of electric shock.
• The product is not a toy. Keep out of reach of children or domestic animals.
• Disconnect the devices from the electrical mains supply before connecting them together.
A
(refer to page 2 for connection information)
• Place the antenna in a favourable position, for example, near a window and/or pointing in
the direction of the television transmitter, and at a safe distance from metal objects, electrical
equipment and reinforced concrete walls that could limit reception.
• Using the cable supplied, connect the antenna to the socket on the rear of the television set
or digital terrestrial decoder. If the decoder is fi tted with an F-female type antenna socket, use
an F-male plug to IEC-female socket adapter (not included).
• The antenna uses an AC/DC power supply unit (supplied); insert the cable into the antenna
power supply socket and connect the power supply unit to a 230 Vac/50 Hz mains power
socket.
• Press button A on the power supply plug to switch the antenna on, and rotate the knob B on
the rear of the antenna counter-clockwise to set it to maximum amplifi cation.
• Check that the LED on the antenna is illuminated, indicating that the power supply is correct.
• Switch the device /TV/DECODER) on and select the desired channel.
• Alternatively, in the case of certain decoders or TV sets, the power supply can be supplied
directly via the antenna cable (see the TV/DECODER manual).
AT55 White
Thank you for choosing MELICONI.
SAFETY WARNINGS
Installation
GB
5