Dometic PERFECTROOF PR2000 Instructions De Montage page 16

Installing the awning
• After gluing, wait until the adhesive has set. For further details, please refer to the
information provided by the sealant manufacturer.
• Seal the bore holes carefully to ensure no moisture can enter.
• Do not open the awning or leave it unattended, before the awning has been
fastened to the mounting rail.
• As part of the regular maintenance procedure, the screws on the rear hinge must
be tightened up by a service partner. Ensure the users of the vehicle are aware of
this.
➤ Install the awning using the instructions in the operating manual enclosed with
your mounting rail.
Installing the mounting bracket
The mounting bracket must be installed if the awning is to be attached to the side of
the vehicle when extended.
➤ Select the location of the installation.
➤ Mark where the holes are to be drilled.
➤ At the marked points, drill holes with a diameter of 3 mm from the outside into
the external wall (fig. 5, page 5).
➤ Put the upper and lower sections of the mounting bracket together.
➤ Clean the outer sides of the lower section and the installation surface in the
vehicle.
I
NOTE
Make sure that no glue gets on to the movable upper section of the
mounting bracket.
➤ To glue and seal, apply an elastic adhesive, such as Sikaflex
the back of the mounting bracket.
➤ Fasten the mounting bracket with drill screws (fig. 5, page 5).
or
➤ Rivet the mounting bracket in place (fig. 5, page 5).
Installing the crank bracket
➤ Install the mounting bracket for the crank at a suitable location inside the vehicle
(fig. 6, page 6).
16
PR2000, PR2500
®
-221 for example, to
EN