Temperature Station; External Sensor; Setting The Language / Time Zone / Time / Date Manually - OWIM HG00073A Instructions D'utilisation Et Consignes De Sécurité

Temperature station

Mark the position of the hole (ø approx.
7.7 mm) on the wall.
Drill the hole with an electric drill.
Insert the dowel
Using a crosshead screwdriver, screw the
screw
26
Hang the temperature station by placing
the hanger

External sensor

Mark the position of the hole (ø approx.
7.7 mm) on the wall.
Drill the hole with an electric drill.
Insert the dowel
Using a crosshead screwdriver, screw the
screw
31
Hang the external sensor by placing the
hanger
Note: Ensure that the external sensor does
not come into contact with water or direct
sunlight. Electronic devices may adversely
affect the wireless signal reception.
Setting the language / time
zone / time / date manually
The reception of DCF radio signal where the
temperature station has been positioned may
become degraded or interrupted. If this hap-
pens you can set the device manually.
1. Press and hold down the CLOCK button
for about 3 seconds.
27
into the dowel.
on the screw.
23
32
into the dowel.
on the screw.
29
into the drilled hole.
into the drilled hole.
22
GB/IE 15