Sonos ZonePlayer 120 Guide D'installation page 9

Sonos ZonePlayer 120 Setup Guide
2
Place ZonePlayer in the room of your choice
Note: Be sure to connect the red ( + ) and black ( - ) terminals from each speaker to
the corresponding terminals on the ZonePlayer. Mismatching of polarities will result
in weak central sound, and a distorted sense of sound direction.
• If you are using speaker wire, use your finger to firmly push the spring-loaded speaker
posts inward to reveal the connection hole. Insert the stripped end of the speaker wire
into the hole, then release. Repeat for the other speaker connections.
• If your speakers have banana connectors, you can insert the plugs
directly into the banana jacks on the back of the ZonePlayer
(available in North America only). Repeat for the other speaker
connections.
Caution: Make sure the voltage switch is set to the proper position for your
household before plugging in your ZonePlayer 120.
• Attach the power cable and plug in your ZonePlayer.
5
Speakers: Power
rating should be at
least 75W for 8
Ohm speakers and
at least 150W for 4
Ohm speakers.