Setting Up New Sonos System - Sonos ZonePlayer 120 Guide D'installation

4

Setting Up New Sonos System

1
Connect to your broadband router
Note: One Sonos component must connect to your broadband router using a
standard Ethernet cable (supplied). Follow the steps below to connect a ZonePlayer
120. If you plan to connect to an external amplifier or to powered speakers, you can
connect a ZonePlayer 90 or 80 instead (purchased separately). If you do not wish to
play music in this room, you can connect a Sonos ZoneBridge (purchased
separately.)
Connect an Ethernet cable (supplied) from any of the Ethernet switch connectors on the back of
your ZonePlayer (or ZoneBridge if purchased separately) to an open port on your router.
• Do not connect the ZonePlayer directly to your cable or DSL modem unless your modem
has a built-in router.
• If you don't have a router, go to http://faq.sonos.com/norouter for instructions.
Make sure the voltage switch is set to the proper position for your household
before applying power to the ZonePlayer 120.
Sonos ZonePlayer 120 Setup Guide
Voltage
switch