General Guidelines; Mounting The Device - HQ Power VDLUV Série Mode D'emploi

shall remain readily operable.
•
Disconnect the device from the mains to clean it or when it is not in use. Handle the power cord by
the plug only.
•
Do not look directly at the light source as sensitive people may go into epileptic seizure if they do.
•
Note that damage caused by user modifications to the device is not covered by the warranty.
•
Keep the device away from children and unauthorised users.
3.

General Guidelines

Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.
•
This device should only be used indoors with an alternating current of 230 V~, 50 Hz.
•
Do not shake the device. Avoid brute force when installing or operating the device.
•
Select a location where the device is protected against extreme heat, dust and moisture.
•
Familiarise yourself with the functions of the device before actually using it. Do not allow operation
by unqualified people. Any damage that may occur will most probably be due to unprofessional use
of the device.
•
All modifications of the device are forbidden for safety reasons.
•
Only use the device for its intended purpose. Using the device in an unauthorised way will void the
warranty.
4. Installation
4.1 Lamps
•
Only fit or replace a lamp when the device is unplugged from the mains.
•
Do not touch the tube with your bare hands. Use a cloth to insert or remove it.
•
Do not install lamps with a higher wattage.
•
Replace any deformed or damaged lamp with a lamp of the same type (see "7. Technical
Specifications"):
1. Gently remove the old lamp from the sockets by turning it until the lamp slides out.
2. Gently insert the new lamp into the sockets and fix it by turning it.
Remark: Do not operate the device when the cover is open.
4.2

Mounting the Device

•
Have the device installed by a qualified person, respecting EN 60598-2-4 and all other applicable
norms.
•
The construction to which the device is attached should be able to support 10 times the weight of the
device for one hour without deformation.
•
Never stand directly below the device when it is being mounted, removed or serviced. Have a
qualified technician check the device once a year and once before you bring it into service.
•
Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
•
Overhead mounting requires extensive experience: calculating workload limits, determining the
installation material to be used... Have the material and the device itself checked regularly. Do not
attempt to install the device yourself if you lack these qualifications as improper installation may
result in injuries.
•
Connect the device to the mains with the power plug. Do not connect it to a dimming pack.
5. Operation
Switch the device on and off by means of the power switch on the device. The UV lamp needs 3 to 4
minutes warm-up time before it reaches its maximum light output.
V. 08 – 15/06/2020
VDLxxUVx
3 ©Velleman nv