HQ Power VDL50MS Mode D'emploi

1. Introduction & Features
Thank you for buying the VDL50MS! Please read the manual thoroughly before bringing this device into service.
Make sure there is no damage caused by transportation. Should there be any, don't install and consult your dealer.
2. Safety Instructions
Be very careful during the installation: touching live wires can cause life-threatening electroshocks.
Do not touch the device during operation as the housing heats up.
Keep this device away from rain and moisture.
Unplug the mains lead before opening the housing.
- Damage caused by disregard of certain guidelines in this manual is not covered by the warranty, and the dealer will
not accept responsibility for any ensuing defects or problems.
- A qualified technician should install and service this device.
- Do not switch the device on immediately if it has been exposed to changes in temperature. Protect the device
against damage by leaving it switched off until it has reached room temperature.
- This device falls under protection class I. It is therefore essential that the device be earthed. Have this device
installed by a qualified technician.
- Make sure that the available voltage does not exceed the voltage stated in the specifications of this manual.
- Do not crimp the power cord, and protect it against damage. Have an authorised dealer replace it if necessary.
- Always disconnect the device from the mains when it is not in use or when you wish to clean it. Handle the power
cord by the plug only. Never tug at the power cord to pull the plug out.
- There may be some smoke or a particular smell when the device is activated for the first time. This is normal and
any smoke or smell will gradually disappear.
- Do not look directly at the light source as sensitive people may go into epileptic seizure if they do.
- Note that damage caused by user modifications to the device are not covered by the warranty. Keep the device
away from children and unauthorised users.
3. General Guidelines
- This device is designed for professional use on stage, in discos, theatres, etc. The VDL50MS should only be used
indoors with an alternating current of max. 230V AC/50Hz.
- Lighting effects are not designed for permanent operation: regular operation breaks will make them last longer.
- Do not shake the device. Avoid brute force when installing or operating the device.
- Select a location where the device will be protected against extreme heat, moisture and dust. Respect a minimum
distance of 0.5m between the projector's light output and any illuminated surface.
- Use an appropriate safety cable to fix the device (e.g. VDLSC7 or VDLSC8).
- Familiarise yourself with the functions of the device before actually using it. Do not allow operation by unqualified
people. Any damage that may occur will most probably be due to unprofessional use of the device.
- Use the original packaging if the device is to be transported.
- All modifications of the device are forbidden for safety reasons.
- Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks, lamp
explosion, crash, etc. Using the device in an unauthorised way will void the warranty.
VDL50MS
VDL50MS – MINI STAR
1 VELLEMAN