Cleaning And Care; Emptying The Dust Container - Cleanmaxx C-320-70 Mode D'emploi

Cleaning and care

NOTE!
■ Empty the dust container when it reaches the MAX mark and clean the cyclone in-
sert, motor fi lters and HEPA exhaust air fi lter regularly in order to prevent the motor
from overheating.
■ Do not clean the HEPA exhaust air fi lter with water!
■ Do not use any corrosive or abrasive cleaners or cleaning pads for cleaning. They
could damage the surface.
Over time the fi lters may become discoloured. This is normal and does not
affect the functionality.

Emptying the dust container

5. Put the dust container in the device: Take it by the handle and insert it bottom fi rst
into the device. Then push the handle towards the device housing until the dust
container audibly clicks into place. Hold the device by the dust container handle and
lift it up to check that the dust container is correctly locked into place.
Cleaning the cyclone insert and motor fi lters
The cyclone insert is situated inside the dust container. The motor fi lters are situated in
the fi lter holder on the cyclone insert.
1. Remove the dust container from the device and empty it (see section "Emptying the
dust container").
2. Turn the lid of the dust container as far as it will go in an anticlockwise direction.
21
1. Push the release button of the dust container and take it
out of the device by the handle.
2. Hold the dust container over an open dustbin. The dust
container should be as close as possible to the dustbin so
that the dust from the container falls only into the bin and
is not spread over the surrounding area.
3. Press the button to open the dust container. The bottom
of the dust container will open and the dirt will fall out.
4. Shut the dust container bottom again. The fastener must
audibly lock into place.
EN