Standard Accessories; Applications - HIKOKI CR 10DL Mode D'emploi

WARNING
If a conductive foreign matter enters in the terminal of lithium
ion battery, the battery may be shorted, causing fi re. When
storing the lithium ion battery, obey surely the rules of
following contents.
○ Do not place conductive debris, nail and wires such as
iron wire and copper wire in the storage case.
○ To prevent shorting from occurring, load the battery in
the tool or insert securely the battery cover for storing
until the ventilator is not seen.
SYMBOLS
WARNING
The following show symbols used for the machine. Be
sure that you understand their meaning before use.
CR10DL: Cordless Reciprocating Saw
To reduce the risk of injury, user must read
instruction manual.
Only for EU countries
Do not dispose of electric tools together with
household waste material!
In observance of European Directive 2012/19/
EU on waste electrical and electronic equipment
and its implementation in accordance with
national law, electric tools that have reached
the end of their life must be collected separately
and returned to an environmentally compatible
recycling facility.
V Rated voltage
n
No-load speed
0
Switching ON
Switching OFF
Disconnect the battery
Swtich lock
Switch unlock

STANDARD ACCESSORIES

In addition to the main unit (1 unit), the package contains the
accessories listed on page 160.
Standard accessories are subject to change without notice.

APPLICATIONS

○ Cutting pipe and angle steel.
○ Cutting various lumbers.
○ Cutting mild steel plates and aluminum plates.
○ Cutting synthetic resins, such as phenol resin and vinyl
chloride.
SPECIFICATIONS
Model
Voltage
No-Load Speed
Stroke
Mild Steel Pipe
Vinyl Chloride
Pipe
Capacity
Wood
Mild Steel Plate
Weight*
* According to EPTA-Procedure 01/2014.
NOTE
Due to HiKOKI's continuing program of research and
development, the specifi cations herein are subject to
change without prior notice.
CHARGING
Before using the power tool, charge the battery as follows.
1. Connect the charger's power cord to the receptacle.
When connecting the plug of the charger to a receptacle,
the pilot lamp will blink in red (At 1- second intervals).
CAUTION
Do not use the electrical cord if damaged. Have it
repaired immediately.
2. Insert the battery into the charger. (Fig. 2)
Firmly insert the battery into the charger till it contacts the
bottom of the charger.
3. Charging
When inserting a battery in the charger, charging will
commence and the pilot lamp will light continuously in
red.
When the battery becomes fully recharged, the pilot lamp
will blink in red. (At 1-second intervals) (See Table 1)
● Pilot lamp indication
The indications of the pilot lamp will be as shown in
Table 1, according to the condition of the charger or the
rechargeable battery.
5
English
CR10DL
10.8 V
0 – 2700 min
–1
13 mm
O.D. 25 mm
O.D. 45 mm
Depth 50 mm
Thickness 4 mm
1.2 - 1.4 kg (BCL1015)