Parallel Cut Adjustment; Switching On And Off - Worksite CSW198 Manuel De L'utilisateur

- Make sure the the blade rotates in the same direction as the tool.
Refer to the direction arrows on the tool and on the saw blade.
- Reinstall the outer flange and
- Turn the blade by hand to make sure the saw blade can run freely.

Parallel cut adjustment

Loosen the parallel guide lock screw (F).
Slide parallel guide (G) through the slots in the base plate (L) to the desired width.
Tighten the parallel guide lock screw (F) to secure it into position.
Ensure that the parallel guide rests are parallel to the base plate to ensure a straight parallel cut.
F

Switching on and off

NOTE
Before engaging the on/off switch, check the saw blade to see if it is fitted properly
and turns smoothly, and that the blade clamp screw is properly tightened.
- Connect the plug to the power supply.
- To start the tool, press the lock-off button (C) and
then press the switch trigger (B).
- To stop the tool, release the switch trigger (B).
- Wait until the saw blade comes to a complete stop
before putting the machine down.
20
washer, and tighten the blade clamp sc rew.
L
centred
G
F
Fig. 3
C
B
Fig. 4