Important Safety Instructions - Worksite CSW198 Manuel De L'utilisateur

16

IMPORTANT SAFETY INSTRUCTIONS

c. Avoid accidental starting. Be sure switch is off before plugging in.
Carrying tools with your finger on the switch or plugging in tools that have
the switch on invites accidents.
d. Remove adjusting keys or switches before turning the tool on. A
wrench or a key that is left attached to a rotating part of the tool may result
in personal injury.
e. Do not overreach. Keep proper footing and balance at all times. Proper
footing and balance enables better control of the tool in unexpected
situations.
f. Use safety equipment. Always wear eye protection. A dust mask, non-skid
safety shoes, a hard hat hat or hearing protection must be used for appropriate
conditions.
! WARNING ! Read and understand all instructions. Failure to follow all
instructions listed herein may result in serious personal injury.
WARNING! When using electric tools, machines or equipment, basic safety
!
and personal injury. Read the entire manual before using this tool.
KEEP THESE INSTRUCTIONS.
5. TOOL USE AND CARE
a. Use clamps or another practical way to secure and support the workpiece
to a stable platform. Holding the work by hand or against your body is
unstable and may lead to loss of control.
b. Do not force tool. Use the correct tools for your application. The correct
tool will do the job better and safer at the rate for which it is designed.
c. Do not use tool if switch does not turn it on or off. Any tool that can not
be controlled with the switch is dangerous and must be repaired.
d. Disconnect the plug from the power source before making any
adjustments, changing accessories or storing the tool. Such preventive
safety measures reduce the risk of starting the tool accidentally.
e. Store tools out of reach of children and other untrained persons.
Tools are dangerous in the hands of untrained users.
f. Maintain tools with care. Keep cutting tools sharp and clean. Properly
maintained tools with sharp cutting edges are less likely to bind and are easier
to control.
g. Check for misalignment or binding of moving parts, breakage of parts
and any other condition that may affect the tool's operation. If damaged,
have the tools serviced before using. Many accidents are caused by poorly
maintained tools.
h. Use only accessories that are recommended by the manufacturer for your
model. Accessories that may be suitable for one tool may become hazardous
when used on another tool.
6. SERVICE
a. Tool service must be performed only by qualified repair personnel.
Service or maintenance performed by unqualified personnel could result in a
risk of injury.
b. When servicing a tool, ask that identical replacement parts be used.
Use of unauthorized parts or failure to follow maintenance instructions may
create a risk of electric shock or injury.
tool.