Removing The Fan - hergom SERE 70 Instructions D'installation, De Service Et D'entretien

2 - REMOVING THE FAN

ATTENTION! Before working on electrical parts
be sure the appliance has been disconnected
from the mains.
In order to replace the fans, observe the following
instructions:
1. Remove the deflector unit, the sides and the
bottom section. Pay attention to vermiculite
parts; they can break. (Fig. 1)
2. Loosen the 4 top screws that secure the fan
assembly and remove it from its housing by
pulling gently upwards. (Fig. 2 and Fig. 3).
FIG. 1
FIG. 2
3. Disconnect the two terminals. Then loosen the
two bottom screws holding the fan in place.
(Fig. 4).
4. Replace the damaged fan and install the fan
assembly by performing the above steps in
reverse order.
FIG. 3
FIG. 4