General Power Tool Safety Warnings - Parkside PMBS 105 A1 Instructions D'utilisation

3. Use the correct accessories and ensure it is in
good condition.
4. Maintain a firm grip on the product but not tense
by the designated handles and wear warm
gloves in cold weather.
5. Maintain the product according to these instruc-
tions and keep it well lubricated.
6. Plan your working time according to these in-
structions to spread higher strain over a longer
period.
Emergency
Familiarise yourself with how to
use the product by reading these
instructions in full. Remember the
safety notices and follow them strictly. This
will help you prevent risks and hazards.
1. Always pay attention when using the
product so as to recognise and respond
to hazards early. Intervening quickly can
prevent serious injuries and property damage.
2. Switch off the product and disconnect
from the power supply if problems
arise. Have the product repaired by a qualified
expert if necessary before using the product
again.
Remaining risks
Even with proper use of this power tool
there are always residual risks. The fol-
lowing hazards may arise in connection
with the construction and design of this
power tool:
a) Injuries and property damage caused by parts
flying about.
b) Damage to health arising from vibration to the
hands and arms when using the power tool for
extended periods or used and maintained im-
properly.
c) Hearing damage when failing to use suitable
hearing protection.
erates an electromagnetic field during use.
This field could possibly actively or pas-
sively impact medical implants. To reduce the risk
of serious or fatal injuries we recommend persons
Introduction / General power tool safety warnings
This power tool gen-
with medical implants consulting their physicians
and the manufacturer of the medical implant before
using this machine!
Wear ear protection!
Total vibration, EN 60745:
Vibration emission value a
Uncertainty K = 1.5 m / s
Note: The vibration level specified in these instruc-
tions was measured in accordance with an EN 60745
standardised measurement process and can be used
to compare equipment. The vibration emission value
specified can also serve as a preliminary assessment
of the exposure.
The vibration level will change according to the
application of the electrical tool and in some cases
may exceed the value specified in these instructions.
Regularly using the electric tool in such a way may
make it easy to underestimate the vibration.
Try to keep the vibration loads
as low as possible. Measures to reduce the vibration
load are, e.g. wearing gloves and limiting the work-
ing time. Wherein all states of operation must be in-
cluded (e.g. times when the power tool is switched
off and times where the power tool is switched on but
running without load).
General power tool
safety warnings
warnings and all instructions.
Failure to follow the warnings and in-
structions may result in electric shock, fire and / or
serious injury.
Save all warnings and instructions for
future reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-op-
erated (cordless) power tool.
= 2.334 m / s
2
h
2
Read all safety
GB 37