Indicator Light - Dimplex RD 907 TS/LCD Instructions De Montage

RD 907 TS/LCD, RD 909 TS/LCD, RD911 TS/LCD
ATTENTION!
Do not use the appliance in flammable atmos-
pheres (e.g. in the vicinity of combustible
gases or spray cans)! Explosion and fire
hazard! Important!
ATTENTION!
Do not insert any foreign objects into the ap-
pliance openings! Risk of injury (electric
shock) and damage to the appliance!
ATTENTION!
Place the appliance so that it cannot be
touched by accident. Risk of burns!
ATTENTION!
Do not place any items of clothing, towels or
similar on the appliance to dry! Overheating
and fire hazard!
The appliance air inlet and outlet openings must
not be obstructed in any way!
The appliance should not be used in areas which
are a fire risk, such as garages, stables, or wooden
sheds.
The appliance will cool down gradually after being
switched off.The appliances is not suitable for con-
nection to permanent wiring!
Only connect the appliance to a properly installed
socket-outlet with earthing contact.
The installation of a residual-current-operated pro-
tective device with a rated tripping current of maxi-
mum 30mA will offer additional protection.
Please contact a qualified electrician.
The socket-outlet must be accessible at all times to
enable the mains plug to be disconnected as
quickly as possible!
The appliance is not suitable for animal breeding
purposes!
The instruction leaflet belongs to the appliance and
must be kept in a safe place. When changing own-
ers, the leaflet must be surrendered to the new
owner!
2. Packaging
After unpacking the appliance, check the same for
transport damage and the contents for completeness!
In the event of damage or an incomplete delivery, con-
tact your authorised retailer!
Do not discard the original box! It can be used for stor-
age and dispatch to avoid transport damage!
Dispose of the packaging material in a proper manner!
Plastic bags should be kept away from children!
www.dimplex.de
3. Location
The appliance should be placed with a minimum dis-
tance of 50cm from flammable objects, walls or other
structures! The appliance openings must not be ob-
structed in any way!
Do not place the appliance on instable surfaces, where
it can tip over!
4. Power cord
Only use an approved extension cord that is suitable
for the appliance rating!
Position the power cord so that it does not pose a trip-
ping hazard and possibly cause the appliance to be
knocked over.
The power cord must not come into contact with hot ap-
pliance parts!
Never pull the plug out of the socket at the cord!
Never move the appliance by pulling at the cord or use
the cord for carrying purposes!
Do not coil the cord around the appliance! Do not use
the appliance with the cord coiled!
This applies particularly if a cable drum is used.
Do not crush the cord or drag it over sharp edges. Do
not place it over heated hotplates or naked flames!
5. Fitting rollers (see Fig. 2 & 3)
Before using the appliance, the rollers must be fit-
ted!
Carefully place the appliance on the floor with the
underside facing upwards. The surface must not be
too hard – paint or appliance damage!
Installing the casters between the outer-most rib on
each end of the radiator and its adjacent rib using
the spring clips provided.
Tighten the wing nuts and carefully turn the radiator
back on the rollers.
6. Start up
To use, insert the plug in the socket.

6.1 Indicator light

The pilot light illuminates when the appliance is heat-
ing.
6.2 Switch (S) (see Fig. 5)
RD 907 TS, RD 907 LCD
RD 909 TS, RD 909 LCD
RD 911 TS, RD 911 LCD
RD9_EN.fm · 10/17/C
Wattage I
Type
[W]
1000
1400
1700
English
Wattage II
[W]
1500
2000
2500
EN-9