Initial Network Configuration - Belkin OmniView Manuel De L'utilisateur

P74238ea_F1DE101G-man.qxd 28-04-2003
Powering Up the RIPC
1. Connect the included power supply unit into an available power outlet.
2. Attach the barrel plug into the power jack located on the rear of the RIPC
to the power unit.
Serial 02
power
Serial 01
LAN
reset
3. Turn on your KVM Switch. If you do not have a KVM Switch, please proceed
with powering up your computers.
09:33 Page 10
INSTALLATION
console CPU/KVM
10
INSTALLATION

Initial Network Configuration

1. Using a RJ45 crossover cable, connect one end to the computer and the
other end to the port labeled "Network".
Serial 02
power
Serial 01
LAN
reset
2. Set the IP address on your computer to be in the same range as 1.2.3.4
(example: 1.2.3.6).
3. Open the Microsoft® Internet Explorer web browser.
4. Enter the IP address "1.2.3.4".
5. Enter the default login name "administrator".
6. Enter the default password "belkin".
11
console
CPU/KVM