Installation In Overflow Pools; Installation In Above-Ground Pools - UWE JetSTREAM TREVI Traduction Des Instructions D'utilisation Et D'installation

2 (230 V)
Measurements in mm
4.3 Installation in Overflow Pools (please unfold the last page, Fig. 2)
With overflow troughs, uwe recommends mounting a brass intermediate frame (9). If the height of the front tuck stone allows, this can be made from
channel sections. Fasten this intermediate frame to the edge of the pool using submergible screws.
Due to the many possible trough shapes and sizes, please make the intermediate frame on-site.
The unit is installed in the same way as described for in-ground pools. However, do not fasten the unit to the edge of the pool, instead drill an M 8 thread
in the intermediate frame and screw the unit to the frame.
3 (230 V)
Measurements in mm
4.4 Installation in Above-Ground Pools (please unfold the last page, Fig 3)
Screw the support (10) (accessory, not included in the delivery) to the underside of the base plate with the 4 plastic hexagon screws provided. Loosen the
retention pins (1) by turning anticlockwise and push the pins apart.
Position the unit as required on the edge of the pool.
The unit must be in a horizontal position.
Positioning the Nozzle
Adjust the nozzle (2) to the water level. To do this, unscrew the hexagon nuts (3) and move the nozzle either up or down to the correct height.
The nozzle must be 20 cm below the surface of the water. The distance from the edge of the pool down to the water level must
not exceed 27 cm
rubber buffer 55, min. 25, max. 80
Width of equipment 350 mm
rubber
buffer 55,
min. 25,
max. 80
2 (400 V)
Measurements
in mm
3 (400 V)
Measurements in mm
14
Width of equipment 350 mm
rubber buffer 55, min. 25, max. 80
rubber
buffer 55,
min. 25,
max. 80