Snooze Function And Background Lighting; Low Battery Indicator; External Sensor Channel Selection - Renkforce 1208067 Notice D'emploi

• Press the ALARM button (14) again to activate or deactivate the alarm. The bell
symbol appears in the display if the alarm is switched on.
• Keep the ALARM button pressed to reach the alarm setting mode. Press the + or -
buttons to enter the desired hour / minute values and press the ALARM button to
confirm the setting.
d) Snooze function and background lighting
• Press the Light / Snooze button (1) to interrupt the alarm clock and activate snooze
function. Press the ALARM button (14) to switch off the alarm for the day.
• The background lighting is activated as soon as the background lighting is connected
to the weather station. Keep the LIGHT/SNOOZE (1) button pressed to switch off the
continual background lighting. Press the LIGHT/SNOOZE (1) button again to activate
this.
• Press the Light / Snooze button (1) when operating the weather station with batteries,
to activate the background lighting for several seconds.
e) Low battery indicator
• The low battery warning display is available for the weather station and external
sensors. Replace the batteries and follow the settings procedure in these operating
instructions.
IMPORTANT: The wind direction must be recalibrated for the wind gage when
using batteries. (Details are found in chapter 9c "Installation and calibration")
f) External sensor channel selection
• Keep the channel/+button or the Search button (12) pressed to search for an external
sensor.
• (Press the + button or -, to set the value and subsequently the Channel/+ button or
Search button (12), to confirm the setting).
Please note: If you press the Channel/+ button or the Search (12) button and
keep pressed, to search for the radio signal, all stored data is deleted when
registering an external sensor.
59