Clock, Calendar, Time Zone; Setting Alarm - Renkforce 1208067 Notice D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

• The antenna symbol
synchronization is still activated). The BARO button (2) must be held down until the
antenna symbol appears in the display to start the search of the DCF signal.
• If the reception fails further on you can attempt it later at other locations. Place
the weather station further away from sources of interference such as mobiles,
household devices, TVs etc.
• Keep the BARO button (2) pressed down until the antenna symbol disappears, to
deactivate the radio controlled reception and stop the daily synchronization.
b) Clock, calendar, time zone
• Press the Clock/Set button (13) to choose between time and calendar.
• Follow the steps below to set the 12/24 hour format, the hours format, day/month
format, time zone offset, the time and calendar.
• Keep the Clock/Set button (13) pressed to reach the time setting mode.
• Use the + or - buttons to correct the selection and the Clock/Set button to confirm (or
skip) the setting in the sequence below:
• Weather Forecast > 12/24hr format > D/M or M/D format > Time Zone Offset > Hr >
Min > Yr > > Month> Date > Temperature unit > Rainfall unit > Wind Speed unit >
Pressure unit > Pressure value > EXIT
• (Weather Forecast > 12/24hr format > D/M or M/D format > Time Zone Offset > Hr
> Min > Yr > > Month> Date > Temperature unit > Rainfall unit > Wind Speed unit >
Pressure unit > Pressure value > EXIT).
You must set the clock and calendar manually if the weather station cannot
receive any DCF signal.
If the device can receive a DCF signal however, you want to change the time
zone, you can select TIME ZONE OFFSET between +12 and -12 hours (this is
the time difference between the radio controlled time and your local time).
The "ZONE" symbol appears in the clock and calendar display mode if you set
the TIME ZONE OFFSET to something other than 0.
c) Setting alarm
• Press the ALARM button (14) to display the alarm time, whereupon the "ALARM"
symbol appears in the display.
58
means the reception has not succeeded (however, the daily

Publicité

Table des Matières
loading

Table des Matières