Switch 12H-/24H-Display; Alarm Function - Renkforce 1267653 Notice D'emploi

d) Switching 12h/24h Display
Briefly push the button „UP"; the time display switches between 12h and 24h mode.
In 12h mode, „PM" is displayed to the left of the time in the second half of the day.
e) Alarm Function
Setting Alarm Time
• Hold down the „ALARM" button pushed for more than 2 seconds until the alarm time
hours flash in the display.
• Set the alarm time hours with the buttons „UP" and „DOWN/DCF". Keep the respective
button pressed for quick adjustment.
• Briefly push the „ALARM" button. The minutes of the alarm time flash. Set them with
the buttons „UP" and „DOWN/DCF". Keep the respective button pressed for quick
adjustment.
• Briefly push the button „ALARM" to leave the setting mode (alternatively do not push
any button for a few seconds).
Switching the Alarm Function On/Off
Briefly press the button „ALARM" to activate or deactivate the alarm function. With
the alarm function switched on, the top of the display shows a small bell between the
hours and the minutes.
Activate Snooze Function or Terminate Alarm
• The alarm signal is activated at the set alarm time; the bell symbol flashes.
• Pushing the button „SNZ" interrupts the alarm signal for the duration of 5 minutes.
During this time, the bell symbol flashes and the symbol „Z
started again.
This procedure can be repeated several times.
• To terminate the alarm signal (or snooze mode), push any other button on the rear of
the weather station (not the button „SNZ").
The alarm signal is automatically terminated after 2 minutes if no button is pushed.
36
". Then the alarm signal is
Z