Shipping And Storage; Care; Plastic Parts - Vermeiren Luna Mode D'emploi

4.2

Shipping and storage

The shipping and storage of the bed shall be according following instructions:
Store in a dry place (between +5 °C and +41 °C).
The relative humidity of the air should be between 30% and 70%.
Provide sufficient covering or packaging to protect the bed from rust and foreign
bodies. (e.g. salt water, sea air, sand, dust).
Store all removed parts together in one place (or mark them if necessary) to avoid
mixing up with other products when re-assembling.
Components must be stored without being subjected to strains (Don't put too heavy
parts on the bed, not clamping between something, ...).
Carefully roll up the power lead with no kinks and place it in the receptacle provided.
Check internal cables for squashing and the prevention of kinks.
4.3

Care

4.3.1 Metal frames, wooden parts
The cleaning of the metal frames and the wooden parts shall be according:
 Clean metal frames and the wooden parts with a cloth moistened with hot
water. Be aware that you don't soak the metal frames and the wooden parts.
 Use a mild commercial detergent for removing stubborn dirt.
Stains can be removed by using a sponge or a soft brush.

 Do not use strong cleaning liquids like solvents, nor use hard brushes.
 Never clean with steam and/or pressure washers.

4.3.2 Plastic parts

Clean plastic parts of your bed with commercial plastic cleaners. Only use a soft brush or
soft sponge.
The motors and the manual unit should only be cleaned with a slightly damp cloth.
4.3.3 Coating
The high quality of the surface layer guarantees optimal protection against corrosion. If the
outer coat is damaged by scratching or in some other way, get your specialist dealer to
repair the affected surface.
When cleaning, only use warm water and normal household detergents and soft brushes
and cloths. Ensure that no wetness gets into the tubes.
Initially the zinc parts only require rubbing with a dry cloth. Stubborn dirt can best be
removed by using a suitable commercial zinc polish.
Page 19
EN
Luna
2010-11