Manual Control Without Lock Function - Vermeiren Luna Mode D'emploi

N
2.2

Manual control without lock function

L
CAUTION:
under supervision only.
This manual control shall be used in combination with the disabling box.
The height of the bed surface, the angle of the backrest and the knee-bend angle can be
adjusted with the manual control. After use the manual control needs to be hung on the side
rail and secured by means of the disabling box.
Following adjustments can be used:
When connecting the manual control to the disabling box please make sure that the
connection plug in the disabling box is especially secure. Proceed as follows:
The connection cable can only be removed from the disabling box after the safety ring has
been removed.
injury -
Risk of Adjustments made by the patient must be allowed
Back section down and up function
Mattress support platform down and up
Leg down and up function
Anti trendelenburg
1. Remove the safety ring from the connection.
2. Insert the connection plug for the manual control in
3. Place the safety ring in the disabling box
the disabling box.
connection so the cable cannot be removed
involuntarily.
Page 8
Luna
2010-11