Switching Between Ems And Tens Mode - Revitive 2836AB Manuel De L'utilisateur

EN
Instructions for use
j Press the
stimulation.
Continue to increase the intensity until you feel
a strong but comfortable tingling sensation without
it causing you pain. You can set the intensity between
1-99.
You can use the buttons on the device or
remote control.
Press the (+) button to increase the level.
Press the (–) button to decrease the level.
If you feel pain or discomfort:
• Lower the intensity of the Body Pads using the
Intensity Control on the device or remote control.
• You can also choose to stop therapy before the end of
the 30 minute session to avoid skin irritation. You can do
this by pressing the
the remote control.
k The
minutes as REVITIVE cycles through its program.
When REVITIVE times out, you will hear three beeps,
and the device will switch itself off automatically.
R
l Ensuring that the device has switched itself off, then
gently peel the Body Pads from the skin.
R
R
Do not pull the Body Pads off the skin using the
Electrode cords as this may damage the cords.
32
4397_IFU02_16220241.indd 32-33
(+) Intensity Control once to start
power button on the device or on
Time display will start to count down in
(–)
Step 5.3:

Switching between EMS and TENS mode

R
R
m Replace the Body Pads onto their plastic liner after use.
R
n Unplug the Electrode cord from the opening on
REVITIVE.
You do not need to detach the Body Pads from the
Electrode cord.
To change between EMS and
press the button of the stimulation mode
you require on the remote control.
During use, switching from EMS to
mode (or vice versa), will reset the timer back
to 30 minutes. The intensity will also be
reset to zero.
EN
R
TENS mode,
TENS
33
25/01/2019 14:51