Revitive 2836AB Manuel De L'utilisateur page 14

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

EN
Instructions for use
Adjusting the intensity level - At the start of therapy there will be 30 seconds of
stimulation to help you set the right intensity level. This is followed by a rest period of
30 seconds, when you will feel no stimulation.
For the remainder of the therapy session you will feel 10 seconds of stimulation,
followed by a 20 second rest period which repeats until the end of therapy.
Adjust the intensity when you can feel the stimulation being applied to your thigh.
It is not possible to adjust the intensity during the rest period.
j
Press the
stimulation.
You can use the buttons on the device or remote control.
Press the (+) button to increase the level.
Press the (–) button to decrease the level.
k Ensure you familiarise yourself with the feeling of
Electrical Muscle Stimulation (EMS). Use on a low
intensity for 20 minutes once per day for a few days.
Set the intensity at a level where you can feel the
stimulation in your feet which creates a calf contraction.
This will likely be less than intensity 40.
It is normal to feel tingling or varying sensations in
your muscles you are treating.
l
After a few days of familiarisation, use a higher intensity
that provides you with strong but comfortable muscle
contractions.
Most people experience a strong contraction at intensity
level 40 or over. You can set the intensity between 1-99.
26
4397_IFU02_16220241.indd 27
(+) Intensity Control, one time, to start
Please note that the intensity required may vary from day
to day.
If you feel pain or discomfort:
• lower the intensity of the Arthritis Pads using either the
Intensity Control on the control panel of the device or on the remote
control.
• You can also choose to stop therapy before the end of the 20 minute
session to avoid muscle fatigue. You can do this by pressing the
power button on the device or on the remote control.
m The time control/display will start to count down in
minutes as REVITIVE cycles through its program.
n When REVITIVE times out, the time display reads 00 and
you will hear three beeps.
o REVITIVE switches itself off automatically.
p Ensuring that the device has switched itself off, then
gently peel the Arthritis Pads from the skin.
Do not pull the Arthritis Pads off the skin using the
Electrode cords as this may damage the cords.
EN
(–)
27
25/01/2019 14:51

Publicité

Table des Matières
loading

Table des Matières