Revitive 2836AB Manuel De L'utilisateur page 9

EN
Instructions for use
Step 2:
Setting up REVITIVE the IsoRocker
a Turn the device over so that you can see the IsoRocker® and IsoRocker Disabler.
• The IsoRocker allows REVITIVE to rock while stimulating your legs & feet.
• REVITIVE will begin rocking on the IsoRocker once muscle contractions
are strong enough.
• The IsoRocker feature can be disabled, by 'opening' the IsoRocker Disabler.
REVITIVE will then be static and it will not rock during use.
b
If you want to use the IsoRocker, leave the
IsoRocker Disabler in place (ie flat) on the of the
device, as shown.
c If you do not want to use the IsoRocker
• Open the IsoRocker Disabler on the bottom of
REVITIVE.
• Pull the IsoRocker Disabler back until it clicks
open, as shown.
• To re-enable the IsoRocker, pull the IsoRocker
Disabler and press into place on the bottom
of the device (ie flat).
16
4397_IFU02_16220241.indd 16-17
®
Step 3:
Powering REVITIVE
REVITIVE can be powered from either the rechargeable battery or by connecting it to
an electrical socket.
Battery power option
If you want to use the device without connecting it to an electrical
socket, it can run from the battery.
When the device is running from the battery, an indicator will show the
remaining battery level.
Full Battery
Follow Step 4 Using The Foot-pads or Step 5 Using the Electrode Body
Pads to continue setting up REVITIVE.
When the battery drops to the low level, it will require recharging.
See Step 6, Recharging Battery on page 34.
If you turn the device off and the low battery level indictor blinks for
10 seconds, the battery requires recharging.
Please note that if the battery runs out, the device can still be used,
by connecting to an electrical socket.
EN
Low Battery
17
25/01/2019 14:50