EN
Putting the wheels on
Adjusting the brakes
Adjustments to the brake should be performed by
trained professionals. If you have sufficient experience,
you can also perform this work yourself.
Brake adjustment
Push the brakes into the correct position.
Then screw the screws back in securely and test the
function.
You should not be able to push the wheelchair when the
brakes are activated.
Drum brake
20
Drive Medical GmbH & Co. KG | As per: 13.03.2018 | Subject to error and change
Before
you
take
the
drive wheels off, secure
the
wheelchair
against
tipping.
Press on the black knob
on the quick-release axle
to release the connection.
Then pull the drive wheel
out.
The interval between the
center mounting bolt and
the tire cover must be
10 mm at the narrowest
place when the brake
mechanism is opened at
its maximum.
To
adjust/correct
the
interval, loosen both of the
screws on the alignment
bar of the parking brake.
To achieve an optimal
braking effect, the braking
force is adjusted with the
adjusting screw.
The
braking
force
is
enhanced by loosening
the adjusting screw.
Important!
Take
care
to
adjust
simultaneously on both
sides of the wheelchair.
Safety belt
An optional safety belt can be added. The secures
and stabilizes the person sitting in the wheelchair. This
effectively prevents the person from tipping forward out
of the wheelchair.
The safety belt is fastened behind on the right and left
to the back tubing. This addition should be done in a
specialized workshop.
Maintenance instructions
We recommend that the entire wheelchair undergo an
inspection by the dealer at least once a year. If there are
problems or defects in the wheelchair, have it repaired
immediately by the dealer.
Disposal
If your wheelchair is no longer being used and is to be
discarded, ask your local disposal company about the
regulations.
Cleaning / maintenance / re-use
Clean regularly with a moist cloth! Do not use any
aggressive cleaning agents!
To disinfect, a spray disinfectant can be used such as
Descosept AF or Bacillol AF.
Check the screws on the wheelchair regularly and
tighten, if necessary.
Check the condition of the tires regularly. They are
"fail-safe", meaning that you do not have to check air
pressure or fill them with air. Always check the tires for
tears or other damage, however.
In case of defects, contact your DRIVE MEDICAL dealer.
This product can be reused. Always follow the
manufacturer's instructions during preparation; these
are made available on request.
Service life
Our company assumes a service life of five years for this
product as long as the product is used as intended and
all maintenance and service requirements are observed.
This service life may be significantly exceeded if the
product is carefully handled, repaired, maintained and
used and there are no technical limits based on the
further development of science and technology.
The service life may also be significantly shortened
through
extreme
and
Determination of the service life by our company does
not represent any additional guarantee.
improper
use,
however.
User Manual Multitec