Preparing For Use; Locking The Backrest; Mounting The Back Cushion; Adjusting The Height Of The Backrest - Drive DeVilbiss Healthcare Multitec Manuel D'utilisation

EN

Preparing for use

Your multifunction wheelchair is usually delivered
completely assembled. Some simple maneuvers will
make it ready for use.
Risk of pinching!
Watch your fingers when folding and setting up the
wheelchair and access the only the parts shown.

Locking the backrest

Mounting the back cushion

Adjusting the height of the backrest

Mounting the seat cushion

16
Drive Medical GmbH & Co. KG | As per: 13.03.2018 | Subject to error and change
Set the backrest upright
and attach the backrest to
the frame base using the
connecting pin. Push the
connecting pin through
the slots and secure the
pin with the locking clip.
Make sure that the pin is
locked securely.
The supplied back
cushion is attached to the
back plate with a Velcro
connection. Make sure that
the back cushion is flush.
To adjust the backrest
height, loosen the 4
hexagon socket screws
in the retaining clips and
move the backrest into
the desired position, then
re-tighten screws.
The seat cushion delivered
with the wheelchair is
fastened to the seat plate
with Velcro.
Ensure that the seat
cushion lies flush.
5

Mounting the armrests

Mounting the leg supports

Mount the leg supports on the brackets on the front
provided for this purpose on the wheelchair. Turn the leg
supports inward.
Ensure that the leg supports are securely in position.

Foot plates

Mounting the headrest

Insert the headrest into the provided bracket on the
backrest. To do this, pull the locking knob (Fig. 10) out
and push the headrest all the way down.
Press the locking knob
and push the side parts/
armrests into the brackets
provided for this purpose
until they click into place.
After you have inserted the
leg supports, rotate the
foot plates downward.
The supporting surface
of the foot plates is
telescopic.
User Manual Multitec