Steering Wheels; Using Your Multifunction Wheelchair; Seat And Back Angle; Adjust Seat And Back Angle - Drive DeVilbiss Healthcare Multitec Manuel D'utilisation

EN

Steering wheels

Remove the screw of the wheel axle and remove the
axle.
Mount the wheel at the desired height and screw the
screw back in.

Using your multifunction wheelchair

Seat and back angle

The seat unit and the backrest angle can be
continuously adjusted with the aid of a pneumatic
spring.
When adjusting the seat and backrest angle, hold the
push handle securely with both hands. Otherwise, there
is a danger of tipping.
The adjustment can only be done under the load of the
user.

Adjust seat and back angle

To prevent the wheelchair from rolling off unintentionally,
first activate the parking brakes.
Hold both push handles securely with your hands.
• Press the left lever for continuous adjustment of the
seat angle. (Fig. 20).
• Press the right lever for continuous adjustment of the
back angle. (Fig. 21).
To perform the desired seat and back angle adjustment,
press the push handles either upwards or downwards.
Release the lever in the desired position.
Check the chosen position for stability.
18
Drive Medical GmbH & Co. KG | As per: 13.03.2018 | Subject to error and change
The height of the steering
wheels can be changed in
three steps.
Danger of tipping!
By adjusting the height of
the steering wheels, the
danger of tipping forward
increases under certain
circumstances.

Leg supports

Raising the leg supports:
To raise the leg supports, loosen the star screw and
push the leg supports into the desired position. Then
retighten the star screw.
Lowering the leg
supports:
To lower the leg supports
again, loosen the star screw
and swing the leg supports
down. Tighten the star screw
back in the desired position.
Taking off the
leg supports:
To take the leg supports
off, first raise the foot
plates.
Pull the locking lever
upwards and swing the
leg supports to the side.
Pull the leg supports up
and out.
When mounting them,
perform the operation in
the reverse order.
Ensure that the leg
supports are correctly
locked.
User Manual Multitec