Declaration Of Conformity - Beta 1947G Mode D'emploi

INSTRUCTIONS FOR USE ISTRUZIONI PER L'USO
Lubrication/Greasing
The pneumatic tool must be connected to a filter-lubricator unit provided with an air-oil microfog mixer,
set at two drops per minute. This will result in a high-performing tool and wear-resistant mechanical
parts.
If lubrication is not provided to the line, oil ISO 32 must be periodically poured into the pneumatic tool,
through the air supply hole.
TROUBLESHOOTING
PROBLEMS
Gun does not deliver
grease when trigger is
pressed.
Slow, irregular grease
extrusion.
MAINTENANCE
Maintenance and repair jobs must be carried out by trained personnel only. For such jobs, you can
contact Beta Utensili's repair centre.
DISPOSAL
The pneumatic tool, accessories and packaging should be sent to a waste disposal centre, in
accordance with the laws in force in your country.
WARRANTY
This tool is manufactured and tested in accordance with current EU regulations, and is covered by a
12-month warranty for professional use or a 24-month warranty for nonprofessional use.
We will repair any breakdowns caused by material or manufacturing defects by fixing the defective
pieces or replacing them at our discretion.
Should assistance be required once or several times during the warranty period, the expiry date of this
warranty will remain unchanged.
This warranty will not cover defects due to wear, misuse or breakdowns caused by blows and/or falls. In
addition, this warranty will no longer be valid if any changes are made, or if the pneumatic tool is forced
or sent to the customer service in pieces.
This warranty explicitly excludes any damage to people and/or things, whether direct or consequential.

DECLARATION OF CONFORMITY

We hereby declare, assuming full responsibility, that the described product complies with all the relevant
provisions of Machine Directive 2006/42/EC and amendments thereto.
The Technical Brochure is available at:
BETA UTENSILI S.P.A.
Via A. Volta 18,
20845 Sovico (MB)
ITALY
CAUSES
1 Power supply failure.
2 Grease was not fed correctly.
1 Thick material.
2 Poor pressure.
3 Air bubble formation in material
to extrude.
SOLUTIONS
1 Check power supply mains.
2 See grease feeding instructions.
1-2 Adjust power supply pressure.
3 Check that material
and operating temperature match
those stated in table.
EN I
02/05/2017
11